They are engineered and manufactured in Europe, for all applications where a fine mist must be obtained with the sole action of water or liquids, at low pressures in the range between 3 bar and 10 bar. The stainless steel versions can work also at higher pressures (<50 bar) or very high pressures (<150 bar), thus please specify ever  to Spraytecs the working pressure range before order and install these hydraulic atomizers in case of working pressures greater than 10 bar, to receive help in selecting atomizers body version code.

Flow rates, threads and spray angles are on request, because we can manufacture this class of atomizers on request, in special versions and also for small quantities.

The dimensional characteristics of the threaded parts of the nozzles are highly accurate and complying European EN standards rules about tolerances for some class of components.

The body and internal swirler are made of different grade stainless steels (AISI 303, 316, 416 SS) or in Polypropylene, in order to offer the best solution in your application of the nozzle, with medium or highly aggressive liquids or in high temperature working conditions or chemical particular characteristics.

The suitable strainer is available for every Spraytecs Hydraulic Atomizer, with mesh characteristics related to the nozzle performances. In case of presence of a line  filtration system, it is possible to buy the sole Hydraulic Atomizer.

The stainless steel versions is easy to be disassembled, to clean in case of any clogging.

The technical solutions adopted in these atomizers are the best choice against leakages or problems related to thermal material dimensional variations.

Please contact us to obtain an offer about your next Spraytecs engineered spray device.

The below shown Spraytecs hydraulic atomizer is equipped of the optional strainer in the liquid inlet:

The below shown Plastic (Polypropylene) Spraytecs hydraulic atomizer is equipped of the anti-drip device and a strainer in the liquid inlet:

Here below shown the Spraytecs hydraulic atomizer data sheets:

 The above shown flow rate diagram is valid also for all other Spraytecs atomizers with flow rate = 0.036 lpm/3 bar, for all different spray angles.

Moreover:

Check with SPRAYTECS for critical dimension, pressure, capacity, fluids in your applications, in order to receive support in your decision.

Nozzle materials must meet correctly chemical composition of fluids in your processes, always remember it.

Spray angle performance varies with pressure. Contact SPRAYTECS for specific data on your critical applications.