These SPRAYTECS nozzles produce flat sprays characterized by low and medium flow rates, and small and medium size droplets.
The flat jet is formed by the concentration of the drops at the nozzle outlet (orifice), which form angles of different amplitudes according to the parameters of the project.
In this case, the spray is produced on the same line with respect to the axis of the feed tube of the nozzle, then defined "axial" .
The droplets produced by these nozzles SPRAYTECS are of small and medium diameter, with spray angles between 20° and 120°, obtained by means of the adoption of a special form of orifice, which determines flow rate and droplet size.
These flat jet nozzles have a high impact and a high efficiency, this means that employ a smaller amount of fluid to obtain the spray angles of the desired coverage.
They have not good resistance to occlusions, because their minimum free passage is quite small. It is therefore recommended to use clean fluids, not containing suspended big parts that can affect the functionality of the nozzle.
To obtain the certainty of a good service of these SPRAYTECS nozzles, the use of fluids without heavy impurities is recommended. This may be obtained with the adoption of an adequate filtering of the fluids which must be used by these nozzles.
These spray nozzles are suitable for the following applications :
- lubrication
- foam control
- foam spraying
- filter cleaning
- spray cleaning
- washing processes
- belt cleaning
- coating
- steam cleaning
- degreasing
- gravel washing
- cooling
- surface treatment
- phosphating
- rain curtains
Note that these SPRAYTECS nozzles are available in brass and in stainless steel, in the flow rates and spray angles indicated in the tables.
The picture on the left shows the spray pattern of these nozzles
Check with SPRAYTECS for critical dimension, pressure, capacity, fluids in your applications, in order to receive support in your decision.
Nozzle materials must meet correctly chemical composition of fluids in your processes, always remember it.
Spray angle performance varies with pressure. Contact SPRAYTECS for specific data on your critical applications.
